// Button Input pullup demo
// Connect to D19
// Note: no debounce logic

const int BUTTON_PIN = 19; // GIOP19 pin connected to button

// Variables will change:
int lastState = LOW;  // the previous state from the input pin
int currentState;                // the current reading from the input pin

void setup() {
  // initialize serial communication at 9600 bits per second:
  Serial.begin(115200);
  // initialize the pushbutton pin input
  // the pull-up input pin will be HIGH when the switch is open and LOW when the switch is closed.
  pinMode(BUTTON_PIN, INPUT_PULLUP);
}

void loop() {
  // read the state of the switch/button:
  currentState = digitalRead(BUTTON_PIN);

  if(lastState == HIGH && currentState == LOW)
    Serial.println("The button is pressed");
  else if(lastState == LOW && currentState == HIGH)
    Serial.println("The button is released");

  // save the the last state
  lastState = currentState;
}